Fits underneath the door and holds it steady while drilling and fitting locks. No set-up time needed. No more searching and alternative door stops. Padded to prevent door and floor damage. For doors up to 55 mm thick.
Holds door on its edge while routing hinge recess & mortise for locks. Holds door securely. Non-scratch base. Adjustable clamp for doors 32 mm to 55 mm thick. Allows door to be tilted back to assist fitting into frame. Maximum door weight 58 kg.
The two-part Contractor Hinge Jig is a portable fully adjustable block template set designed for recessing hinges in wooden doors & frames using a plunge router. It is easy to use with minimal setting-up time, completing the job both accurately & quickly. Used on-site & in joinery shops to increase productivity with excellent results. Fully adjustable apertures for fire door requirements and renovation work. Can be used on both inside and outside doors, and on maximum 25 mm thick fixed stops. Ideal for fitting a new door in an old frame. No need for marking out in a conventional way. Quick & simple to set up as the hinge is used as the pattern. Clean & accurate recesses are achieved every time. Suitable for timber-based doors & square butt hinges. Use with a light-duty plunge router with 1/4 inch collet. Long reach router cutter required, 12 mm diameter with 70 mm overall length. Adjustable edge guides with pre-set for the hinge of 20 mm, 25 mm and 30 mm Unbiased may be needed. Patent No. GB2490139 T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160. 3 x Hinge sliding aperture block assemblies 4 x Brad awls (short blade) 1 x 16 mm guide bush 1 x Carry case