Call for pricing
A two part trade hinge jig to cut hinge recesses in doors & linings using a plunge router.
Two part, splits into two lengths with jointing plate.
Hard wearing template in 12 mm phenolic plastic.
One set up for door and frame. No need to adjust for repeated doors.
Four adjustable apertures.
For a 2-metre door hinges are 6 inch down and 9 inch up and the middle. Fourth hinge for fire doors (355 mm /14 inches down from top of top hinge).
For doors 16 mm to 51 mm thick with separate (plant on) stops, or stops thinner than 11 mm.
Swivel end plate for 3 mm gap to head of door.
Use with a light duty plunge router with 1/4 inch collet.
Includes three edge guides, three brad awls and 16 mm guide bush.
Unibase may be needed.
T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.
3 x Bradawl with spacers
3 x Edge guides
1 x 16 mm guide bush
1 x Hex key
1 x Carry case