Close
Filters

TORK CRAFT 16MM TILES CORE BIT

TORK CRAFT 16MM TILES CORE BIT

R105,00 incl VAT
The diamond core bit is used to drill holes in: Ceramic tiles Marble Grade 5 porcelain (hardest) Granite Glass Slate The diamond core cuts faster, smoother, and lasts longer than any other core drills.
- +
Manufacturer: Tork Craft
Availability: In stock
SKU: TA80816
Manufacturer part number: TC180816

How to use the diamond core bit:

The diamond core drill bit must be used with water at all times when drilling. The water serves as a coolant to prevent the diamonds from overheating. The maximum allowable temperature for a diamond core bit is 500°C.

There is no pilot drill with the diamond core bit. A low rpm rotary drill with a planetary gearbox is required to be used with a diamond core bit. It is possible to use a cordless drill but in the lowest gear setting. No hammer action is used.

  1. Tightly fasten the diamond core bit in the drill's chuck.
  2. Keep the bit steady at a 45° angle with the starting point on the edge of the assigned area to be drilled whilst the bit is rotating.
  3. A notch will be made (this is normal). Gradually move the drill from 45° to 90° and continue drilling until finished.
  4. Allow the diamond core bit to cool down completely before proceeding to drill another hole.

Water can be applied by:

  • spraying water on the surface,
  • using a wet sponge,
  • attaching a water feed device. This is necessary when drilling into a wall tile.
Write your own review
  • Product can be reviewed only after purchasing it
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent