Close
Filters

TORK CRAFT 5MM DIAMOND CORE BIT FOR TILES

TORK CRAFT 5MM DIAMOND CORE BIT FOR TILES

R53,00 incl VAT
The diamond core bit is used to drill holes in: •Ceramic tiles •Marble •Grade 5 porcelain (hardest) •Granite •Glass •Slate The diamond core cuts faster, smoother and lasts longer than any other core drills.
- +
Manufacturer: Tork Craft
Availability: In stock
SKU: TA80805

5MM DIAMOND CORE BIT FOR TILES

How to use the diamond core bit:

The diamond core drill bit must be used with water at all times when drilling. The water serves as a coolant to prevent the diamonds from overheating. The maximum allowable temperature for a diamond core bit is 500°C.

There is no pilot drill with the diamond core bit. A low rpm rotary drill with a planetary gearbox is required to be used with a diamond core bit. It is possible to use a cordless drill but in the lowest gear setting. No hammer action is used.

  1. Tightly fasten the diamond core bit in the drill's chuck.
  2. Keep the bit steady at a 45° angle with the starting point on the edge of the assigned area to be drilled whilst the bit is rotating.
  3. A notch will be made (this is normal). Gradually move the drill from 45° to 90° and continue drilling until finished.
  4. Allow the diamond core bit to cool down completely before proceeding to drill another hole.

Water can be applied by:

  • spraying water on the surface,
  • using a wet sponge,
  • attaching a water feed device. This is necessary when drilling into a wall tile.

Write your own review
  • Product can be reviewed only after purchasing it
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent