THIS IS A DISPLAY MODEL AND COMES AS IS, NO RETURNS WILL BE ALLOWED BUT THE FULL GUARANTEES STILL APPLY. LIMITED STOCK. Jet JWS-34KX - professional milling machine with a powerful engine (especially in 3-phase version) and a massive cast-iron work table. The design with replaceable spindle allows to considerably expand a spectrum of solved problems. The 30 mm spindle included in the equipment corresponds to the standards of most modern manufacturers of cutting tools, and 32 mm (sold separately) - to the domestic one. Instead of a spindle, it is possible to install collet clamps for operation with end mills. A unique feature of JWS-34KX is the ability to perform some grinding operations: as an option, a spindle with a set of bushings for abrasive sleeves with a diameter of 25 to 100 mm is available, they are used mainly for finishing edges. The machine is equipped with an accurate milling stop. Its massive cast-iron body is combined with the fence of the cutter and a 100-mm branch pipe of the dust extractor. For adjustment, move it entirely, and after adjusting the protrusion of the rear (receiving) lining using a precise screw mechanism with a millimetre scale. For milling at an angle, the stop is designed with a transport scale (included in the standard equipment) or a small movable cast-iron table (optional), equipped with a work clamp and a conveying stop. Both devices move along the T-slot in the working table.
DISPLAY / USED STOCK SOLD AS-IS. WARRANTIES STILL APPLY. Ideal for crosscutting of thick timber eg roof construction etc.Top tracking arm can swing 0-45⁰ left & right allowing for angled cuts. The blade can also tilt to the left- from a vertical 90⁰ to the table, right down to 0⁰ (ie parallel to the table) to allow the cutting of slots or cutting compound mitres. The blade can also swivel from 90⁰ to 0⁰ (ie parallel to the fence) in order to allow rip cuts (either inboard or outboard). Blade can also be raised right up to 95mm above the table to allow for trenching cuts. The machine is mounted on a very sturdy 4 legged sheet metal construction. The cutting table is made from 20mm MDF with a repositionable fence and is easy to replace if it gets worn out. Worktable size is 810mm from back to front and 1010 mm from left to right. Space required in the workshop from the wall is 1100mm.
PLEASE NOTE, THIS IS A DISPLAY/DEMO MODEL - SCRATCH & DENT CONDITIONS APPLY. The Toolmate Pro TMPAFB15 Air Filter is intended for the average home workshop, especially where hand sanding takes place. The air passes through the electrostatic pre-filter into the main pleated filter, filtering 98% of all particles 5 microns in size and 86% of all particles 1 micron in size.