Nova Handwheel DVR/1624

Allows a rounded recess in wood to be cut to a square recess with the use of a hammer. Ideal for squaring hinge recesses in door frames and door edges, as well as lock face plates. Spring loaded high speed steel (HSS) anvil for a sharp cut and long life. Lightweight aluminium body design. Can be used with the Trend Hinge Jig. Can be resharpened.

The Robert Sorby medium tear drop cutter, like its big brother (Large Teardrop RS213C) provides a multi-facetted, highly efficient cutting edge. The shape of the cutter effectively converts the tool into a round, half-round or square scraper suitable for use on the inside or outside of bowls, platters and hollow forms. Use the straight edge on outside curves and the rounded shapes for internal curved shapes. A great all rounder that supports traditional scraping and shear scraping techniques. This cutter is also available in Robert Sorby’s high performance, titanium nitride coated, Excelsior series. Sharpening: Use a diamond file or honing stone flat across the top face. To gain best results and increase the longevity of the cutter this simple procedure should be done little and often. Use the 472 cutter holder to reshape the profile on the Robert Sorby ProEdge or on a grinding wheel. Related Products: This cutter is designed for use with the following tools: Multi-tip Hollowing Tool (RS200KT, RS200

For anyone turning salt and pepper mills using a CrushGrind mechanism, this is an essential tool in obtaining the correct depth and size of recesses needed to enable the mechanism to work correctly. The step or shoulder of the tool gives an accurate position of the recess required for the base section of the mill. The small V notch on the right hand side allows the other groove to be produced in the top section when it is lined up with the outer face. The CrushGrind tool will give accurate and effortless results time and again.

2MT Center, suitable for all lathes with a 2MT tailstock Solid 4 prongs for secure work holding Used in the headstock Precise machined medium tensile carbon steel Standard equipment on all NOVA lathes

Our new NOVA 1/2″ Drill Chuck is a precision chuck for use with our NOVA Wood lathes and NOVA DVR Drill Presses. Perfect drill chuck accessory for NOVA Lathes, or any lathe or drill press with a 2MT spindle. It can hold 1/6 inches/1.58mm through to 1/2inch/12.7mm.

Accessory for NOVA Chucks to quickly and accurately make the dovetail recess for the chucking of a bowl. Ensures a dovetail with a sharp, clean edge to precisely match to the dovetail contour of NOVA Accessory Jaws. Creates maximum holding power to your NOVA Chuck. Scaled with a handy mark out scale for use as a guide.